Enterasys Networks RBTSA-AB Manual Do Utilizador

C

HAPTER

 3: C

ONFIGURING

 

THE

E

THERNET

 A

DAPTER

As part of system maintenance, you should save and back up the 
configurations of individual Ethernet Adapters in case you need to reload 
them in the future. The backup saves all the parameters of the selected 
Ethernet Adapter in a file on your computer. The file can be used later to 
restore the configuration on this or another Ethernet Adapter.

1 Set the Ethernet Adapter parameters in the System Configuration pages.

2 Under Tools, click Backup Wireless Ethernet Adapter.

3 In the next page, click Backup Now.

4 Specify a name and location for the backup, and click OK.

If you have stored a backup configuration on your computer, you can 
restore the configuration as follows:

1 Under Tools, click Restore Wireless Ethernet Adapter.

2 In the next page, click Browse and select the backup file to upload.

3 Click Restore.

The configuration is restored and activated on the Ethernet Adapter. This 
operation may cause the Ethernet Adapter to reboot.

If the Ethernet Adapter was using an IP address setting other than the 
backup, restoring the configuration will change the IP address. If you 
want to continue configuring the Ethernet Adapter, do the following:

1 Close your browser.

2 Return to the Enterasys Networks Wireless Infrastructure Device Manager and 

click Refresh.

3 Select the device and click Configure to start a new configuration session.

To log out of the Configuration Management System, click Logout under 
Tools.