Raritan Computer EMX2-111 Manual Do Utilizador
Chapter 3: Getting Started
48
2. The LCD display shows the reading or state of the selected sensor in
the middle of the LCD display.
For a numeric sensor's reading, the appropriate measurement unit is
displayed to the right of the reading.
displayed to the right of the reading.
% is displayed for a humidity sensor.
is displayed for a temperature sensor.
For a discrete sensor, either of the following sensor states is
displayed.
displayed.
on: The sensor is in the abnormal state.
oFF: The sensor is in the normal state.
Note: Numeric sensors use numeric values to indicate the
environmental or internal conditions while discrete (on/off) sensors
use alphabetical characters only to indicate the state changes.
environmental or internal conditions while discrete (on/off) sensors
use alphabetical characters only to indicate the state changes.
3. If your EMX device has more than one SENSOR ports, press the
FUNC button to display the physical port number of the
environmental sensor. The port number is shown as "P:X," where X
is the port number. For the onboard contact closure sensor, it is
displayed as CC1 or CC2.
environmental sensor. The port number is shown as "P:X," where X
is the port number. For the onboard contact closure sensor, it is
displayed as CC1 or CC2.
4. Press the FUNC button to display the X, Y and Z coordinates of the
sensor respectively.
X coordinate is shown as "x:XX," where XX are the first two
numeric digits entered for the X coordinate in the web interface.
Y coordinate is shown as "y:XX," where XX are the first two
numeric digits entered for the Y coordinate in the web interface.
Z coordinate is shown as "z:XX," where XX are the first two
numeric digits entered for the Z coordinate in the web interface.
If one or both of the first two digits for a specific coordinate are
alphabetical characters, one or two underscores are displayed in
place of the alphabetical characters.
alphabetical characters, one or two underscores are displayed in
place of the alphabetical characters.
5. Press the FUNC button again to display the serial number of the
sensor, which is shown as "s:XX," where XX are two digits of the
serial number. The LCD will cycle through the serial number from the
first two digits to the final two.
serial number. The LCD will cycle through the serial number from the
first two digits to the final two.
For example, if the serial number is AE17A00022, the LCD display
shows the following information one after another:
shows the following information one after another:
s:AE --> s:17 --> s:A0 --> s:00 --> s:22
If no button is pressed after tens of seconds, the LCD display returns to
the sensor reading or state.
the sensor reading or state.