RGB Spectrum Quadra User's Guide Manual Do Utilizador
F I R M W A R E U P G R A D E S A N D T R O U B L E S H O O T I N G
System Troubleshooting
350-7951
Quadra User’s Guide
112
.
. .
.
.
•
Try selecting a different output from the “
” to better match your display.
•
Determine that there is not a mismatch between your
output and the selected monitor display (e.g., 4:3 output
and 16:9 display monitor).
output and the selected monitor display (e.g., 4:3 output
and 16:9 display monitor).
•
Use the “
” (WSR) and
” (WDR) functions to
check or modify the image’s aspect ratio.
Blank image (the output is
black)
black)
•
Ensure that the source is properly connected to the system,
powered on and generating a signal.
powered on and generating a signal.
•
Ensure that the correct input type is selected using the
“
“
” command.
Frozen image
If an image is frozen after system start-up, turn freeze off using the
“
“
” command.
Missing imagery
•
Check the “
” (WSR) value
to ensure the entire image is being processed.
•
Check WSR and “
”
(WDR) to ensure that the source and destination
rectangles are delivering the entire video image.
rectangles are delivering the entire video image.
Poor quality video
•
Check the video source for proper operation.
•
Check that cables are in good condition and connected
correctly.
correctly.
•
Ensure that video sources are not double terminated.
Double termination can occur when one video source is
split into two using a “T” connector instead of a
distribution amplifier.
Double termination can occur when one video source is
split into two using a “T” connector instead of a
distribution amplifier.
•
If you are using a VCR, check the quality of the tape.
•
Adjust the brightness using the “
” command.
•
Adjust contrast using the “
” command.
•
Adjust saturation as required using the “
”
command.
•
Adjust the hue as required using the “
” command.
No color on the S-Video
input
input
•
Check that the “
” setting is set to normal.
Adjust as necessary.
•
Check that the S-video cable is connected correctly.
•
Check that S-Video has been selected as the source using
the “
the “
” command. If you select
Composite2 when you have an S-Video signal connected
to this port, the input will be displayed as a black and
white (luminance only) signal.
to this port, the input will be displayed as a black and
white (luminance only) signal.
Aspect Ratio on a video
input is incorrect.
input is incorrect.
Check the status of the “
” command. For a 4:3
aspect ratio signal, this should be set to normal.
Table D-1.
Troubleshooting Guide(Continued)
Symptom
Recommendations