Hawking Technology HWU54D Manual Do Utilizador
General Connection Setting
Channel
Selects the radio channel to be used for wireless networking.
The channel setting of the wireless stations within a network
should be the same.
The channel setting of the wireless stations within a network
should be the same.
Parameter Description
Tx Rate
Tx Rate
There are several options including
Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select.
When the “Auto” is selected, the device will choose the most
suitable transmission rate automatically. The higher data rate
you designated in the network, the shorter distance is allowed
between the adapter and the wireless stations.
When the adapter works in 11b mode, the maximum data rate
is 11Mbps so that there are only “Auto/1/2/5.5/11Mbps”
options you can select.
Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select.
When the “Auto” is selected, the device will choose the most
suitable transmission rate automatically. The higher data rate
you designated in the network, the shorter distance is allowed
between the adapter and the wireless stations.
When the adapter works in 11b mode, the maximum data rate
is 11Mbps so that there are only “Auto/1/2/5.5/11Mbps”
options you can select.
SSID
The SSID (up to 32 printable ASCII characters) is the unique
name identified in a WLAN. The ID prevents the unintentional
merging of two co-located WLANs.
You may specify a SSID for the adapter and then only the
device with the same SSID can interconnect to the adapter.
name identified in a WLAN. The ID prevents the unintentional
merging of two co-located WLANs.
You may specify a SSID for the adapter and then only the
device with the same SSID can interconnect to the adapter.
Any
If “Any“ check box is enabled, the adapter will survey and
connect to one of the available wireless stations without
checking the consistency of channel and SSID with the
wireless station.
connect to one of the available wireless stations without
checking the consistency of channel and SSID with the
wireless station.
Network Type
Ad-Hoc – This mode enables wireless network adapters to
connect without use of an AP or Router. Select this mode if
there is no AP or Router in the network.
Infrastructure – This operation mode requires the presence
of an 802.11 Access Point. All communication is done via the
Access Point or Router.
connect without use of an AP or Router. Select this mode if
there is no AP or Router in the network.
Infrastructure – This operation mode requires the presence
of an 802.11 Access Point. All communication is done via the
Access Point or Router.
Change/Apply Clicking “Change/Apply“ will allow the configuration of the
parameters in the “General Connection Setting“ tab. Clicking
Apply will confirm and enable the adjusted settings.
Apply will confirm and enable the adjusted settings.
Encryption Setting
In this block, users may enable/disable WEP and WPA
encryption within the network. Please refer to Section
3.3 for a more detailed description.
encryption within the network. Please refer to Section
3.3 for a more detailed description.
16