ZyXEL Communications P-870HW-I Manual Do Utilizador
P-870HW-I1 User’s Guide
106
Chapter 6 Wireless LAN
6.4.8 General Wireless LAN Screen: WPA2-PSK
Use this screen to enable and configure WPA2-PSK encryption in your wireless network. To
open this screen, click Network > Wireless LAN, and set Security Mode to WPA2-PSK.
open this screen, click Network > Wireless LAN, and set Security Mode to WPA2-PSK.
Figure 53 Network > Wireless LAN > General > WPA2-PSK
The following table describes the labels in this screen.
Accounting
Server
These settings are optional.
Active
Select this to enable user accounting through an external authentication server.
IP Address
Enter the IP address of the external accounting server in dotted decimal notation.
Port Number
Enter the port number of the external accounting server. You need not change this
value unless your network administrator instructs you to do so.
Shared Secret
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the ZyXEL Device. The key must be the
same on the external accounting server. The key is not sent over the network.
Table 41 Network > Wireless LAN > General > 802.1x + No WEP (continued)
LABEL
DESCRIPTION
Table 42 Network > Wireless LAN > General > WPA2-PSK
LABEL
DESCRIPTION
Security Mode
Select WPA2-PSK.
WPA
Compatible
Select this if the ZyXEL Device should be able to handle WPA-PSK and WPA2-PSK,
depending on the abilities of each wireless station. This requires additional
processing and may reduce throughput.
Pre-Shared
Key
Type a pre-shared key from 8 to 63 ASCII characters (including spaces and symbols).
The key is case-sensitive.
ReAuthenticati
on Timer
Specify how often wireless stations have to resend usernames and passwords in
order to stay connected. Enter a time interval between 10 and 9999 seconds.