ZyXEL Communications P-870HW-I Manual Do Utilizador
P-870HW-I1 User’s Guide
Chapter 6 Wireless LAN
111
Figure 59 OTIST: In Progress on the Wireless Client
These screens close when the transfer is complete.
6.5.1 Notes on OTIST
1 If you enable OTIST in a wireless client, you see this screen each time you start the
utility. Click Yes to search for an OTIST-enabled AP (in other words, the ZyXEL
Device).
Device).
Figure 60 Start OTIST?
2 If an OTIST-enabled wireless client loses its wireless connection for more than ten
seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually
have the wireless client search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
have the wireless client search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
3 After the wireless client finds an OTIST-enabled AP, you must click Start in the ZyXEL
Device’s Network > Wireless LAN > OTIST screen or hold in the Reset button on the
ZyXEL Device for one or two seconds to transfer the settings again.
ZyXEL Device for one or two seconds to transfer the settings again.
4 If you change the SSID or the keys on the ZyXEL Device after using OTIST, you need to
run OTIST again or enter them manually in the wireless client(s).
5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run
OTIST. Therefore, if a new OTIST-enabled wireless client joins your wireless network,
you need to run OTIST on the AP and ALL wireless clients again.
you need to run OTIST on the AP and ALL wireless clients again.
6.6 MAC Filter Screen
Use this screen to enable and configure MAC filtering in your wireless network. To open this
screen, click Network > Wireless LAN > MAC Filter.
screen, click Network > Wireless LAN > MAC Filter.