ZyXEL Communications 2 Plus Manual Do Utilizador

Chapter 41 Firmware and Configuration File Maintenance

ZyWALL 2 Plus User’s Guide

Figure 410   Example Xmodem Upload 

After the firmware upload process has completed, the ZyWALL will automatically restart.

1 Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 

24.7.2 - System Maintenance - Upload System Configuration File. Follow the 
instructions as shown in the next screen.

Figure 411   Menu 24.7.2 As Seen Using the Console Port 

2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on 

your computer. Follow the procedure as shown previously for the HyperTerminal 
program. The procedure for other serial communications programs should be similar.

3 Enter “atgo” to restart the ZyWALL.

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload system configuration file:     
1. Enter "y" at the prompt below to go into debug mode.     
2. Enter "atlc" after "Enter Debug Mode" message.     
3. Wait for "Starting XMODEM upload" message before activating        
   Xmodem upload on your terminal.     
4. After successful firmware upload, enter "atgo" to restart 
   the system.     

Warning:     
1. Proceeding with the upload will erase the current        
configuration file.     
2. The system's console port speed (Menu 24.2.2) may change when it is 
restarted; please adjust your terminal's speed accordingly. The password 
may change (menu 23), also.     
3. When uploading the DEFAULT configuration file, the console        
port speed will be reset to 9600 bps and the password to "1234".
                           
         Do You Wish To Proceed:(Y/N)