Klaxon 102325 Folheto
Installation Instructions
Flashguard LED Flasher Module
To Flashguard Xtra
1.
Straighten the two LEDs by gently bending them in to
the upright position.
the upright position.
2.
Peel the backing off the adhesive mounting brackets
provided and attach them to the inside of the cover as
shown below.
provided and attach them to the inside of the cover as
shown below.
6 cm
3.
Connect the unit to a suitable 12V supply, observing
polarity. The two LEDs will now flash alternately.
polarity. The two LEDs will now flash alternately.
4.
Slot the PCB into the mounting brackets with the LEDs
pointing towards the lens. Bend the LEDs into position if
required.
pointing towards the lens. Bend the LEDs into position if
required.
5.
Fix the unit to the wall in the same way as an ordinary
simulated unit.
simulated unit.
Wrigley Street, Oldham, Lancashire. OL4 1HW
Tel +44 (0)161 287 5555 Fax +44 (0)161 287 5511
E-mail sales@klaxonsignals.com www.klaxonsignals.com