Adtran MX2800 M13 Manual Do Utilizador

3-40    

61200290L1-1G

Section 3, Configuration

MX2800 M13 Multiplexer User Manual

This option defaults all settings for the unit. Once the settings have been successfully retrieved, Command 
Accepted will appear at the bottom of the screen

The User Account Management table is also reset to default.

Select 

Update Flash Software

 from the Utilities menu to update software, using either XModem protocol 

or TFTP.

Before beginning update of Flash software, disable the Auto Save feature
of the MX2800. From the 

Configuration

 menu, choose 

System

Management

, then select 

Auto Save

 and toggle until it is set to 

Disable

.

Updating the Flash Software via XModem requires that a VT100 terminal menu session be active through 
the units craft port. To update the software via XModem, follow these steps:

1. From the MX2800 Main Menu, select 

Configuration

, then 

Utilities

, then 

Update Flash Software

, and 

then 

Update via XModem

. 

2. Once it has been determined where the new binary file is located, select 

Start 

to begin the transfer.

3. Once 

Start

 has been selected, start the XModem transfer from the terminal menu program that is being 

used by selecting or typing the file path for the location of the new binary file. Refer to the appropriate 
documentation for the terminal emulator to begin XModem transfer.

4. After the binary file has been selected, the XModem transfer will begin. To cancel a transfer in 

progress, press 

C

TRL

+X

 three times. The 

LED on the active card is solid amber for the duration of 

XModem transfer. The 

 LED on the standby card is flashing green.

5. If updating a unit with redundant controller cards, the active controller will begin uploading the new 

code to the standby controller after the XModem transfer has completed and the unit has successfully 
loaded and programmed the new software into its Flash memory. If the unit does not have redundant 
controller cards, go to 

6. While the standby card is having code uploaded, the 

LED on the standby card will be solid 

amber. After the code has finished uploading to the standby card, the card will reset itself and begin 
running the new code.