Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Allied Telesis
  4. AT-TQ2403
  5. Manual Do Utilizador

Allied Telesis AT-TQ2403 Manual Do Utilizador

Download
Página de 292
 
AT-TQ2403 Management Software User's Guide 
21 
Chapter 2: Setting up the AT-TQ2403 
Management Software 
Setting up and deploying one or more AT-TQ2403 Management Software is in effect creating and 
launching a wireless network. The Kick Start utility and corresponding AT-TQ2403 Management 
Software Basic Settings web page simplify this process. This chapter contains procedures for setting up 
your AT-TQ2403 Management Software and the resulting wireless network. 
This chapter includes the following procedures: 
  Running Kick Start to Find Access Points on the Network 
  Logging in to the AT-TQ2403 Management Software 
  Configuring the Basic Settings and Starting the Wireless Network 
Running Kick Start to Find Access Points on the Network 
Kick Start is an easy-to-use utility for discovering and identifying new AT-TQ2403 Management Software. 
Kick Start scans the network looking for access points, displays ID details on those it finds, and provides 
access to the AT-TQ2403 Management Software. 
 
 
Note: Kick Start recognizes and configures only AT-TQ2403 Management Software. Kick 
Start will not find or configure non AT-TQ2403 Management Software and will not find any 
other devices. 
 
 
Note: Run Kick Start only in the subnet of the internal network. 
 
 
Note: Kick Start finds only those access points that have IP addresses. IP addresses are 
dynamically assigned to access points if you have a DHCP server running on the network. If you 
deploy the access point on a network with no DHCP server, the default static IP address 
(192.168.1.230) is used. 
 
 
Caution: Use caution with non-DHCP enabled networks: Do not deploy more than one new 
access point on a non-DHCP network because they will use the same default static IP 
addresses and conflict with each other. (For more information, see “
”.) 
 
To start the discovery process, perform the following procedure: 
1.  Do one of the following to create an Ethernet connection between the access point and your 
computer: 
 
Connect one end of an Ethernet cable to the LAN port on the access point and the other 
end to the same hub where your PC is connected. 
Or 
 
Connect one end of an Ethernet cable to the LAN port on the access point and the other 
end of the cable to the Ethernet port on your PC.