Allied Telesis AT-TQ2403 Manual Do Utilizador
AT-TQ2403 Management Software User's Guide
271
access-point Guest, VLAN and VWN settings
ap-list
ap-list
AP list for rogue AP detection
bss
Basic Service Set of radios
channel-planner Channel planner settings
cluster
Clustering-based configuration settings
config
Configuration settings
dhcp-client
DHCP client settings
dot11
IEEE 802.11 (all radios)
firmware-upgrade Upgrade firmware of the AP through http
host
Internet host settings
interface
Network interface
log
Log settings
mac-acl
MAC address access list item
management Management communication configurations
ntp
Network Time Protocol client
portal
Guest captive portal
radio
Radio
radius-user RADIUS user
serial
Serial access to the command line interface
snmp
SNMP (Simple Network Management Protocol)
ssh
SSH access to the command line interface
static-ip-route Static IP route entry - used when DHCP is off
system
System settings
telnet
Telnet access to the command line interface
traphost
Destination host for SNMP trap
tx-queue
Transmission queue parameters
untagged-vlan Untagged VLAN configuration
vwn
Virtual Wireless Network
web-server Web server
wme-queue Transmission queue parameters for stations
Example 5: Type "set mac" TAB, and the command will complete with the only matching option:
AT-TQ2403# set mac-acl
Example 6: Type "set cluster" TAB TAB, and the two matching options are displayed:
AT-TQ2403# set cluster
cluster-name
Name of cluster to join
clustered
Whether clustering is enabled on this node
location
Location
Example 7: Type "add" TAB TAB (including a space after add) to get a list of all property options
for the add command.
AT-TQ2403# add
ap-list
AP list for rogue AP detection
basic-rate
Basic rates of radios
bridge-port
Bridge ports of bridge interfaces
bss
Basic Service Set of radios
interface
Network interface
mac-acl
MAC address access list item
radius-user
RADIUS user
supported-rate Supported rates of radios
traphost
traphost
Destination host for SNMP trap
Example 8: Type "remove" TAB TAB (including a space after remove) to get a list of all property
options for the remove command.