Cisco Systems WRP400 Manual Do Utilizador

Regional page

ATA Administration Guide

153

Voice tab > Regional page >

Vertical Service Activation Codes are automatically appended to the dial-plan. 
There is no need to include them in dial-plan, although no harm is done if they are 
included. 

CPC Delay 

Delay in seconds after caller hangs up when the ATA 
device starts removing the tip-and-ring voltage to the 
attached equipment of the called party. Range: 0–255 
seconds. ATA device has had polarity reversal feature 
since release 1.0 which can be applied to both the caller 
and the callee end. This feature is generally used for 
answer supervision on the caller side to signal to the 
attached equipment when the call has been connected 
(remote end has answered) or disconnected (remote end 
has hung up). This feature should be disabled for the called 
party (in other words, by using the same polarity for 
connected and idle state) and the CPC feature should be 
used instead.

Without CPC enabled, reorder tone will is played after a 
configurable delay. If CPC is enabled, dial tone will be 
played when tip-to-ring voltage is restored Resolution is 1 
second.

The default is 2.

CPC Duration 

Duration in seconds for which the tip-to-ring voltage is 
removed after the caller hangs up. After that, tip-to-ring 
voltage is restored and dial tone applies if the attached 
equipment is still off-hook. CPC is disabled if this value is 
set to 0. Range: 0 to 1.000 second. Resolution is 0.001 
second.

The default is 0 (CPC disabled). 

Call Return Code 

This code calls the last caller. 

The default is *69.

Call Redial Code 

Redials the last number called. This field is not found in the 
PAP2T.

The default is *07.