Cisco Systems WRP400 Manual Do Utilizador

Line page

ATA Administration Guide

166

The SPA2102 provides one User tab for each Line tab (User 1 and User 2), where 
many of the line-specific configuration parameters are contained. The SPA8000 
does not provide User tabs, but consolidates all the line-specific parameters on 
the Line tab. 

Voice tab > Line page >

Voice tab > Line page >

Line Enable 

To enable this line for service, select yes. Otherwise, select 
no.

The default is yes.

Trunk Enable

To add this line to a trunk group, choose the trunk group 
number. Otherwise, choose none. This feature is available 
on the SPA8000 only.

The default is none.

SAS Enable 

To enable the use of the line as a streaming audio source, 
select yes. Otherwise, select no. If enabled, the line cannot 
be used for outgoing calls. Instead, it auto-answers 
incoming calls and streams audio RTP packets to the caller.

The default is no.

SAS DLG Refresh 
Intvl

If this value is not zero, it is the interval at which the 
streaming audio server sends out session refresh (SIP re-
INVITE) messages to determine whether the connection to 
the caller is still active. If the caller does not respond to the 
refresh message, the ATA device ends this call with a SIP 
BYE message. The range is 0 to 255 seconds (0 means that 
the session refresh is disabled).

The default is 30.