Cisco Systems WRP400 Manual Do Utilizador
ATA Voice Field Reference
PSTN Line page (SPA3102)
ATA Administration Guide
201
B
Voice tab > PSTN Line page >
Dial Plans section
FAX Enable T38
To enable the use of the ITU-T T.38 standard for faxing,
select yes. Otherwise, select no.
select yes. Otherwise, select no.
The default is yes.
FAX Tone Detect
Mode
Mode
This parameter has three possible values:
caller or callee - SPA will detect FAX tone whether it is
callee or caller
callee or caller
caller only - SPA will detect FAX tone only if it is the caller
callee only - SPA will detect FAX tone only if it is the callee
The default is caller or callee.
Symmetric RTP
(SPA3102 only) Enable symmetric RTP operation. If
enabled, the SPA3102 sends RTP packets to the source
address and port of the last received valid inbound RTP
packet. If disabled (or before the first RTP packet arrives)
the SPA3102 sends RTP to the destination as indicated in
the inbound SDP.
enabled, the SPA3102 sends RTP packets to the source
address and port of the last received valid inbound RTP
packet. If disabled (or before the first RTP packet arrives)
the SPA3102 sends RTP to the destination as indicated in
the inbound SDP.
The default is yes.
Dial Plan 1/2/3/4/5/
6/7/8
6/7/8
Dial plan script for this line.
The default is (xx.) Dial plans in the dial plan pool to be
associated with a VoIP Caller or a PSTN Caller. Each dial
plan in the pool is referenced by a index 1 to 8
corresponding to Dial Plan 1 to 8. The dial plan syntax is the
same as that used for Line 1.
associated with a VoIP Caller or a PSTN Caller. Each dial
plan in the pool is referenced by a index 1 to 8
corresponding to Dial Plan 1 to 8. The dial plan syntax is the
same as that used for Line 1.