Digi 90031300 Manual Do Utilizador
T1 Modem Bank
6
Planning Worksheets
The T1 Modem Bank must be configured to match the provisioning of the T1 line from the carrier.
General Information
Required information includes the following:
•
The identity of the WAN manager for your local and remote sites
•
The identification of the TELCO providing the WAN
Table 3
Requirements for T1 Modem Bank Setup
Requirements
Description
Location of the T1 Modem
Bank
Bank
The T1 Modem Bank must be positioned where it can be connected to the WAN
within the specified cable limits.
within the specified cable limits.
Active T1 line
One or more active and installed T1 lines from the WAN service with at least two
channels assigned.
channels assigned.
Ground Start or Loop Start
CSU supervision mode
Circuit ID
Identifier used by the T1 provider to refer to the line. It refers only to the T1 line and
is not associated with individual phone numbers. You must keep track of the circuit
ID number for each line, since if you experience trouble on the T1 line, the service
provider will need to know this number.
is not associated with individual phone numbers. You must keep track of the circuit
ID number for each line, since if you experience trouble on the T1 line, the service
provider will need to know this number.
You can make as many copies as you need of the worksheet on the following page. A copy of this worksheet should
also be filled out for both the local and remote sites.
also be filled out for both the local and remote sites.