Digi 90031300 Manual Do Utilizador
T1 Modem Bank
24
6. Place the cursor on “Dual-Ported Mem Address” and press <Enter>. A screen similar to the following will
appear:
The following address choices are available:
Below 1 Megabyte:
*
80000h
88000h
90000h
98000h
A0000h
A8000h
B0000h
B8000h
C0000h
C8000h
D0000h
D8000h
E0000h
E8000h
F0000h
F8000h
Above 1 Megabyte:
F0000000h F1000000h F2000000h F3000000h
F4000000h F5000000h F6000000h F7000000h
F8000000h F9000000h FA000000h FB000000h
FC000000h FD000000h FE000000h FF000000h
F4000000h F5000000h F6000000h F7000000h
F8000000h F9000000h FA000000h FB000000h
FC000000h FD000000h FE000000h FF000000h
*
Although there are 16 choices offered for memory start addresses below 1 megabyte, a limited number of these
choices is likely to be available. Of the 16, the best choices are probably D0000 and D8000. See Appendix A
on page 85 for more information.
choices is likely to be available. Of the 16, the best choices are probably D0000 and D8000. See Appendix A
on page 85 for more information.
Multiple EISA EPC/X host adapters may share the same addresses.
7. Use the cursor keys to select one of the listed addresses, or press <Enter> to accept what the configuration pro-
gram has chosen. Write this address down—you will need to know it when installing the device driver soft-
ware.
ware.
8. Leave
the
Dual-Port Mem Enbl/Dsbl at “Disabled”.
9. Leave
the
Interrupt Configuration at “Disabled”.
10. Pull down the SYSTEM menu, and choose “Exit”. Make sure that you SAVE the new configuration as the
program suggests.
11. Go to “Connecting the EPC/X Host Adapter to the T1 Modem Banks” on page 25.