Digi 90031300 Manual Do Utilizador

Software Installation

35

See the AccelePort EPC/X device driver installation instructions in the Digi AccelePort Intelligent Serial
Communications Products Novell AIO Device Driver Package Software Manual (manual part no. 92000243). This
manual is included with the T1 Modem Bank package.

Follow the instructions in the Novell manuals to install NetWare Connect on the system to which the T1 Modem
Banks are directly connected. Alternatively, you can use another AIO application like Cheyenne FaxServe or Funk
Software’s Wanderlink.

SNMP is pre-installed on NetWare.

If you wish to manage the T1 Modem Banks remotely with QuickManager, you must follow these additional steps:

1.  Configure the SNMP on the Novell system. This is done via the SNMP.NLM load line parameters or within

INETCFG.NLM. Please see the Novell documentation for instructions.

 
2.  Install SNMP on a Windows NT system on the network. Use the following procedure to install SNMP on the

NT system:

a)  Double click Control Panel.

b)  Double click the Network icon.

c)  When the “Network” window appears, select “Services”, then click the “Add” button.

d)  Select “SNMP Service.”

If you wish to manage the T1 Modem Banks remotely with QuickManager, you will need to install QuickManager
on a Windows NT system on your network. Use the following procedure to install QuickManager:

1.  Insert the T1 Modem Bank NT Setup Disk into drive A of the remote system operating under Windows NT.

2. Run 

A:\SETUP.EXE.