Digi 90031300 Manual Do Utilizador

T1 Modem Bank

46

The following describes the display panel configuration/diagnostic process:

1.  Press Right

Displays current node number

Press Left changes node number

2.  Press Right

Line Card T1 Line Select

Press Left selects Line Interface or Drop & Insert

3.  Press Right

goes to Diagnostic Test 1

(if no left press at Line Card T1 Line Select)

 

4.  Press Right

if Drop & Insert    

Press Left changes EQ

0.6 1.2 1.8 2.4 3.0

5.  Press Right

goes to Diagnostic Test 1

 

6.  Press Right

if Line Interface

Press Left selects CSU Long Haul or DSX-1 Short Haul

7.  Press Right

if CSU Long Haul

Press Left selects AMI/D4 or B8ZS/ESF

 

8.  Press Right

either AMI/D4 or B8ZS/ESF

Press Left selects Jitter, EGL, LBO

9.  Press Right

goes to Diagnostic Test 1

(if no left press to select Jitter, EGL, LBO)

 

10.  Press Right 

if Jitter

Press Left selects Rx or Tx

11.  Press Right

go to step 8 above

 

12.  Press Right

if EGL

Press Left selects 26 or 36

13.  Press Right 

go to step 8 above

 

14.  Press Right

if LBO

Press Left selects

00 75 15 22

15.  Press Right

go to step 8 above

By pressing <Enter> at any time, you may exit the configuration/diagnostic mode without saving any of your
changes. The POST will then resume if it had not been completed at the time you entered configuration/diagnostic
mode. If POST had been completed when you entered configuration/diagnostic mode, the download will begin when
you exit configuration/diagnostic mode.

To exit the configuration/diagnostic mode and save your changes, cycle the T1 Modem Bank’s power off, then on
again to return to the initialized state.