Deutsche Telekom 504PC SE Manual Do Utilizador

39

Configuration via Telephone

Please see the chapter entitled "Remote Configuration" on p. 62.

To configure the system using a telephone, please proceed as follows:

• Start the configuration mode with your PIN (default setting is 0000).

• The configuration procedures can be carried out one after the other. When you

have completed one procedure, usually by pressing the hash key, you simply con-
tinue selecting the code digits for the next procedure.

• If you hear a negative acknowledgement tone, it means that the procedure has

been aborted and your input has not been saved. Start the procedure again and
make your input. When you hear a positive acknowledgement tone, this means that
your input has been saved.

• Exit the configuration mode. If you do not exit the configuration mode manually,

this will be done automatically four minutes after the last input.

As long as the configuration mode is active, call protection is automatically activated
on the telephone used, which means that you cannot be called.

When you lift the handset in the configuration mode, you always hear a special inter-
nal dialling tone.

If you attempt to configure the Eumex 504PC SE via a telephone while it is already
being configured via another telephone or a PC, you will hear a busy tone.

You can edit the presettings and configure the Eumex 504PC SE according to your
personal requirements. There are three ways of doing this: you can use a PC and
menus (see the chapter entitled "Configuring the System" on p. 68), a connected tele-
phone (only possible with DTMF telephones), or the remote TeleService (0180  2 55
66 55).