Adtran Express XL Manual Do Utilizador
Quick Startup Guide
4
Express XL/XLT User Manual
61200070L1-1
11. Enter the IP address and Netmask parameters of the access server at the
remote site. This creates a static route to the access server’s network which
is entered into the Express XL/XLT’s IP route table.
is entered into the Express XL/XLT’s IP route table.
12. Move the cursor over the RIP menu. Check with the network administra-
tor for the type of routing protocol used. The Express XL/XLT supports
RIP versions 1 and 2. The protocol is set in the Protocol parameter.
RIP versions 1 and 2. The protocol is set in the Protocol parameter.
13. Select Yes for the Triggered parameter. This will prevent periodic RIP up-
dates that keep the ISDN link from going “idle.”
14. Select Yes for the Retain parameter. This will allow the routes learned
from the access server to be saved in the IP routing table. Access to any of
those networks from the workstation will cause this profile to be dialed.
those networks from the workstation will cause this profile to be dialed.
15. Use the left arrow to get back to the previous menu. Use the down arrow
to view the IPX menu parameters in the right pane.
16. This is similar to steps 13 and 14. Select Yes for Triggered and Yes for Re-
tain
. This will allow the ISDN link to go to an idle state and permit the
Express XL/XLT to “spoof” the server information obtained from the ac-
cess server. A similar configuration must be selected on the access server.
cess server. A similar configuration must be selected on the access server.
17. Use the arrows to get the Dial Out menu parameters for this profile.
18. Enter the phone number of the access server in Number 1. If configured
18. Enter the phone number of the access server in Number 1. If configured
by the administrator to use two B-channels using Multilink PPP, set the
Initial Channels
Initial Channels
field to 2. Some PPP protocols, if they exist in the access
server, will allow the second channel to come into play only if the band-
width is needed. If this is the case, the Express XL/XLT will automatically
negotiate this with the access server.
width is needed. If this is the case, the Express XL/XLT will automatically
negotiate this with the access server.
19. Now move to the Bandwidth menu for this profile. Once there, use the
right arrow to move to the On Demand submenu.
20. Set the Mode parameter to On. This enables the dynamic bandwidth fea-
tures of the Express XL/XLT.
21. Select the Idle Timeout parameter and enter the number of seconds the
Express XL/XLT should wait before hanging up the connection when no
traffic is present. A value of 120 seconds is typical. A value of 0 means nev-
er idle the link.
traffic is present. A value of 120 seconds is typical. A value of 0 means nev-
er idle the link.
22. All the parameters for this Connection List profile are complete. To save
them, press the left arrow to get to the top (main) menu; when prompted
Save Connection List changes?
Save Connection List changes?
enter y.
23. Set up the computer workstation’s IP and IPX parameters as instructed by
the network administrator. The Express XL/XLT’s IP address should be
the computer’s default gateway.
the computer’s default gateway.