Adtran IPR-S1000 Manual Do Utilizador

87

pid_list:  This mandatory field must be filled in by a list of Program stream
IDentifiers (PID). The PID minimum value is 0 and its maximum value is 8191.

pkt_count: The program will stop

 

after receiving this number of TS packets.

 

timeout: The program will stop after this number of seconds.

Note: With the Shell interface, it is possible not to set a timeout nor

a packet count limit. The user can then stop the program at any time

using CTRL C.

To obtain information on sections and attributes, you must use
the «get» or «set» command, according to your need.

Example:     get dvb.fec 
                     (press «Enter» to get the answer)

If the value is a list of values, the separating character is the
comma «,». If the value is made up of several elements, the
separating character is the semicolon «;».

Example: 

    

set ip.routes_iface = 192.168.31.0/24 ; PPP, 192.168.1.0/24 ; ETH

In that case, the value is a list of made up values. The two
elements of the list are the following: 

192.168.31.0/24 ; PPP and

192.168.1.0/24 ; ETH. Each element contains two values. For the first
one: on the one hand, the target network address, and on the other
hand, the PPP interface.

Note: One of the elements of a made up value can, in certain cases,

be empty. For example: set ip.routes_gateway = 192.168.31.0/24 ;

192.168.1.254 ; ,192.168.2.0/24 ; 192.168.1.254 ; 192.168.1.3

In that case, the first route is made up of three elements:
- the target network 192.168.31.0/24
- the gateway 192.168.1.254
- the address of the interface is empty

bandwidth.size
Allows to reduce the capacity of reception of the receiver by
parameterizing the bandwidth limiter of the receiver card.

dvb.bauds
DVB baud rate [1-45000] in KBauds.