Lucent Technologies PortMaster Manual Do Utilizador
Configuration Steps for a Synchronous V.25bis Connection
14-12
PortMaster Configuration Guide
Testing the Configuration
The configuration should be tested before the location boston is set for continuous
dialing. To test the configuration, follow these steps:
dialing. To test the configuration, follow these steps:
1.
Enter the following commands to connect from the office in Miami to
location boston.
location boston.
Command> set console w1
Command> set debug 0x51
Command> dial boston
Command> set debug 0x51
Command> dial boston
2.
Monitor the dial-and-connect sequence between the two locations.
3.
If everything connects as expected, do the following:
a.
Turn off debugging on the console.
Command> set debug off
Command> reset console
Command> reset console
b.
Reset the port on the Office Router in Miami and change the location type of
location boston to on-demand.
location boston to on-demand.
Command> reset w1
Command> set location boston on_demand
Command> set location boston on_demand
4.
If you notice a problem, do the following:
a.
Reset the port.
b.
Check your configuration.
c.
Dial Boston again.
d.
Repeat this procedure until the connection is made correctly.
5.
When you have configured the PortMaster correctly, reset the port and
save the configuration.
save the configuration.
Command> reset w1
Command> save all
Command> save all