Lucent Technologies PortMaster Manual Do Utilizador

To determine current syslog settings, enter the following command:

Command> show syslog

When you log in using !root, administrative logins to the serial ports are enabled by 
default. You can disable or enable them by using the following command

:

Command> set serial-admin on|off

If administrative login is disabled, you can still use port S0 (or C0) by setting the console 
DIP switch (first from the left, also known as DIP 1) to the up position.

You can dynamically assign IP addresses to PPP or SLIP dial-in users. By assigning 
addresses as needed from a pool, the PortMaster requires fewer addresses than if each 
user is assigned a specific address. When a dial-in connection is closed, the address goes 
back into the pool and can be reused. 

When creating an address pool, you explicitly identify the first address in the sequence 
of addresses available for temporary assignment. The PortMaster allocates one address in 
the pool of addresses for each port configured for network dial-in.

To set the value of the first IP address to assign for dial-in ports, use the following 
command:

Command> set assigned_address Ipaddress

4

Warning messages

5

Normal but significant messages

6

Informational messages

7

Debug-level messages

Syslog Priority Keywords (Continued)