Adtran 1200305L1 Manual Do Utilizador
Section 4, User Interface Guide
ATLAS 550 System Manual
188
© 2002 ADTRAN, Inc.
61200305L1-1F
M
ODULES
(BONDING) > S
TATUS
> N
UM
BC
HANNELS
Read security: 5
Displays the number of bearer channels used in this BONDING session. When the number is displayed in
the format X/Y, Y is the number of BONDING resources reserved for this session, and X is the number of
calls belonging to this session that are up. If just a number is displayed, then all calls are up, and the
number displayed is the number of BONDING resources in use for this session.
the format X/Y, Y is the number of BONDING resources reserved for this session, and X is the number of
calls belonging to this session that are up. If just a number is displayed, then all calls are up, and the
number displayed is the number of BONDING resources in use for this session.
M
ODULES
(BONDING) > S
TATUS
> D
ATA
R
ATE
Read security: 5
Displays the data rate for this BONDING session. The number in the parenthesis is the data rate of the
individual bearer channels.
individual bearer channels.
M
ODULES
(BONDING) > S
TATUS
> B
ONDED
EP
Read security: 5
Displays the slot and port of the terminating endpoint that is using this BONDING session.
M
ODULES
(BONDING) > C
ONFIGURATION
Write security: 3; Read security: 5
All of the following configurable parameters apply to the Nx 56/64 BONDing Resource Module. In most
applications the default values will be correct.
applications the default values will be correct.
M
ODULES
(BONDING) > C
ONFIGURATION
> TXINIT T
IMER
(
SEC
)
Write security: 3; Read security: 5
Specifies the length of time the originating endpoint attempts to detect the BONDING negotiation pattern
from the answering endpoint before deciding the BONDING call has failed.
from the answering endpoint before deciding the BONDING call has failed.
M
ODULES
(BONDING) > C
ONFIGURATION
> TXFA T
IMER
(
SEC
)
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to detect the BONDING frame pattern when a call is
connected before deciding the BONDING call has failed. When interoperating with other manufacturers'
BONDING equipment, it may be necessary to change this time so that it matches
connected before deciding the BONDING call has failed. When interoperating with other manufacturers'
BONDING equipment, it may be necessary to change this time so that it matches
TXADD01
.
M
ODULES
(BONDING) > C
ONFIGURATION
> TXADD01 T
IMER
(
SEC
)
Write security: 3; Read security: 5
Specifies the length of time both endpoints wait for additional calls to be connected at the end of
negotiation before deciding that the BONDING call has failed. The factory default setting is sufficient for
most calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow
for slower call routing.
negotiation before deciding that the BONDING call has failed. The factory default setting is sufficient for
most calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow
for slower call routing.
BONDING
The remaining channels were brought up successfully, and the BONDING
session is now ready to pass data.
session is now ready to pass data.
T
ERMINATED
The BONDING session has been terminated for some reason and is in the
process of freeing BONDING resources.
process of freeing BONDING resources.