McDATA 3000 Manual Do Utilizador
6
6-12
McDATA UltraNet Edge 3000 User Guide
Configuring a 2x2 Ethernet Wide Area Network
4. Click the Finish button to complete the configuration.
5. Right-click on Node 20 and then repeat step 1 through step 4 to
set the licensing information for this node.
6. Continue the configuration process by proceeding to the “Adding
an IP Circuit” procedure.
Adding an IP Circuit
You will now create an IP circuit. A circuit is the IP WAN link
between Node10 and Node20. Use the IP Circuit Wizard to create
and configure the IP circuit by using the following procedure:
between Node10 and Node20. Use the IP Circuit Wizard to create
and configure the IP circuit by using the following procedure:
1. Select the Links tab on the center toolbar.