McDATA 3000 Manual Do Utilizador

McDATA UltraNet Edge 3000 User Guide

Before upgrading your software, use the following procedure to 
verify the current version of software from your PC:

1. Telnet to the UltraNet Edge 3000. 

2. Enter the correct password if previously defined.

3. Issue the following commands to verify the current software 

versions:

tm.0x00> rpm query -a

The current versions of all the software packages will be displayed. 
Below is an example of how the version information is displayed. 

CMNTnucleus-V3.1.1.3

CMNTdiag-V3.1.1.3

CMNTsm-V3.1.1.3

CMNTwebview-V3.2

The first three modules listed in the example above show the current 
version for the UltraNet Edge 3000 OS. The last module listed shows 
the current version of WebView. 

This section explains all of the steps required to replace the chassis 
and upgrade your UltraNet Edge 3000 to the most current software 
version. This procedure is applicable when initiated by on-site 
McDATA field personnel.

This upgrade procedure only applies to UltraNet Edges currently at 

version 3.1.1.1 or higher. Both UltraNet Edge 3000 units must be local.

There are several short procedures required for upgrading the 
UltraNet Edge 3000 in a local environment. Follow the steps 
summarized below:

1. Request License Key from Technical Support

2. Obtain Current Version of UltraNet ConfigManager

3. Power Down the UltraNet Edge 3000 Unit

4. Replace the UltraNet Edge 3000 Chassis and Update UCM

5. FTP the New UltraNet Edge 3000 Software