McDATA 3000 Manual Do Utilizador

McDATA UltraNet Edge 3000 User Guide

6. After the 

tarExtract

 command is complete, issue a 

command to boot up the UltraNet Edge 3000. 

7. Remove any files that were renamed in step .

8. After issuing the 

reset

 command, press 

 to go into prom 

.

9. Issue the 

 command at the prom prompt. 

10. Issue the 

 command after the 

flash_html “romx”

 is 

complete.

11. Using Windows Dial-up Networking, establish a PPP session 

from the local PC to the UltraNet Edge 3000 that has just been 
upgraded.

Using UCM version 3.1.3, deliver the new configurations to the 
UltraNet Edge 3000 that has just been upgraded. 

The UltraNet Edge 3000 will be rebooted after a successful delivery.

This procedure only applies to software upgrades and should not be 
used when it is necessary to replace the chassis. Use the following 
procedure only when upgrading the Edge software from version 
3.1.1.1 or higher:

1. FTP the Edge 3.1.x.x software into the nodes that are being 

upgraded.

Where xx = the most current version of UltraNet Edge 3000 
software.

2. Issue the 

 command (wait for system 

prompt to return).

Where xx = the most current version of UltraNet Edge 3000 
software.

3. Issue the 

 command to reboot the system.

4. Stop the boot process by pressing the 

 key while it is still in 

prom mode.

If you do not reset the UltraNet Edge 3000 after the tarExtract command is completed, the 

box will hang and the prom will be corrupted. This state is unrecoverable.