McDATA 3000 Manual Do Utilizador

 

 

This chapter provides basic information for troubleshooting and 
diagnostics for the UltraNet Edge 3000 product.

Begin the troubleshooting procedures by using the following list to 
check the cables, LEDs, and the network design.

•

Cables - Ensure all cables are plugged into their proper interfaces.

•

LEDs - Use Figure 2-4 and Table 2-9 in Chapter 2 for information 
regarding LEDs.

•

Network  Design:

— Verify that the IP addresses, subnet masks, static routes, and 

the default gateway are correct.

— Ensure that the IP host addresses for all of the UltraNet Edge 

3000 Ethernet interfaces are on different subnets.

The commands listed in this section are useful for troubleshooting 
Fibre Channel and IP interfaces. These commands are issued at the 
main prompt of the user interface on the UltraNet Edge 3000. To 
access the UltraNet Edge 3000 you will need the default password to 
telnet into the box. See the “UltraNet Edge 3000 Security” section in 
Chapter 1.