McDATA 3000 Manual Do Utilizador

 UltraNet™ Edge Storage Router 3000 User Guide 

The following illustration shows a fiber optic cable with a LC 
connector and a fiber optic transceiver. 

1. Grasp the LC connector at the end of the fiber optic cable.

2. Depress the LC connector clip located underneath the LC 

connector before pulling to remove the cable from the I/O. 

The Fibre Channel connection uses the standard LC connector. The 
interface card uses either short wave (multi-mode) or long wave 
(single-mode) transceivers. (see 

 for the specifications). Instructions for removing and 

installing the transceivers are found in 

.

This section provides cabling procedures for the 10/100 Ethernet 
interface. The interface comes standard with a short wave 
(multi-mode) transceiver. A long wave (single-mode) is not available 
for this interface type.

1. Locate the I/O interface configured as 10/100 Ethernet.

2. Locate the Ethernet cable with the RJ-45 connector.

3. Align the RJ-45 cable connector with the RJ-45 jack on the 

Ethernet card. Gently insert the connector.

Sb128

LC Connector Clip

Fiber Optic
Transceiver

Fiber Optic
Cable

Z

e0088