Adtran 1203870G1 Manual Do Utilizador

Página de 90
NetVanta 3200/3300/3400 Series
 Unit Installation
61200860L1-34AB
Copyright © 2012 ADTRAN, Inc.
65
Figure 30.  Repositioning the Mounting Bracket for Wall Mounting the NetVanta 3205/3305
Instructions for Wall Mounting NetVanta 3205/NetVanta 3305
Step
Action
1
Remove the mounting ears. Rotate them 90
o
 so that the portion of the bracket with the mounting holes is 
flush with the bottom of the chassis, and reattach them to the chassis (see 
). 
2
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so 
that the LEDs are viewable. 
Important! Mount the chassis with LEDs facing to the side as shown in 
 (not facing up or 
down).
3
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall 
stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide 
sufficient long-term stability. 
4
Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in length) wood 
screws through the unit’s brackets and into the mounted board. Se
.
5
Proceed to the steps given in 
.