Netopia 2200 Manual Do Utilizador

207

‘Waiting for DSL’ is displayed while the Gateway is training. This 
should change to ‘Up’ within two minutes. If not, make sure an RJ-11 
cable is used, the Gateway is connected to the correct wall jack, and 
the Gateway is not plugged into a micro filter.

‘No Connection’ is displayed if the Gateway has trained but failed the 
PPPoE login. This usually means an invalid user name or password. 
Go to Exper t Mode and change the PPPoE name and password.

‘Up’ is displayed when the ADSL line is synched and the PPPoE (or 
other connection method) session is established.

‘Down’ is displayed if the line connection fails.

This should be the valid PPPoE username. If not, go to Exper t Mode 
and change to the correct username.

This is the negotiated address of the Gateway’s WAN inter face. 
This address is often dynamically assigned. Make sure this is a valid 
address.
If this is not the correct assigned address, go to Exper t Mode and ver-
ify the PPPoE address has not been manually assigned.

This is the negotiated address of the remote router. Make sure this is 
a valid address.
If this is not the correct address, go to Exper t Mode and verify the 
address has not been manually assigned.

These are the negotiated DNS addresses. Make sure they are valid 
DNS addresses. (Secondar y DNS is optional, and may validly be blank 
(0.0.0.0).)
If these are not the correct addresses, go to Exper t Mode and verify 
the addresses have not been manually assigned.

This is the unique serial number of your Gateway.

(if so equipped; not available on 3342/3342N/3352/3352N) This is 
the status of your Ethernet connection. If you are connecting via Ether-
net, it should be Up.

This is the status of your USB connection (if equipped). If you are con-
necting via USB, it should be Up.

This is the version number of the current embedded software in your 
Gateway.

This is the date that your Gateway was installed and enabled.