Netopia 2200 Manual Do Utilizador
247
CONFIG Commands
DMT Settings
DSL Commands
set dmt type [ lite | dmt | ansi | multi | adsl2 | adsl2+ | readsl2 |
adsl2anxm | adsl2+anxm ]
adsl2anxm | adsl2+anxm ]
Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL)
protocol to use for the WAN inter face.
protocol to use for the WAN inter face.
Beginning with Firmware Version 7.6, the
type value also supports the following settings
on cer tain model units:
adsl2, adsl2+, readsl2, adsl2anxm, adsl2+anxm.
☛
NOTE:
Some
dmt type settings are now supported for many Annex B (335xN) plat-
forms. 2200 Series and 33xxN Series models are suppor ted. Currently,
adsl2anxm and adsl2+anxm are not supported in Annex B.
adsl2anxm and adsl2+anxm are not supported in Annex B.
set dmt autoConfig [ off | on ]
Enables suppor t for automatic VPI/VCI detection and configuration. When set to
on (the
default), a pre-defined list of VPI/VCI pairs are searched to find a valid configuration for
your ADSL line. Entering a value for the VPI or VCI setting will disable this feature.
your ADSL line. Entering a value for the VPI or VCI setting will disable this feature.
set dmt wiringMode [ auto | tip_ring | A_A1 ]
(not suppor ted on all models) This command configures the wiring mode setting for your
ADSL line. Selecting
ADSL line. Selecting
auto (the default) causes the Gateway to detect which pair of wires
(inner or outer pair) are in use on your phone line. Specifying
tip_ring forces the inner pair
to be used; and
A_A1 the outer pair.
set dmt metallic-termination [ auto | disabled | always_on ]
(not suppor ted on all models) Beginning with firmware version 7.5.2, this command allows
you to apply a sealing current to “dr y” DSL lines so that the wiring doesn’t corrode.
you to apply a sealing current to “dr y” DSL lines so that the wiring doesn’t corrode.