Netgear WNDAP620 Manual Do Utilizador

802.11b/g/n and 802.11a/n Standards–Based Wireless 

Networking

The wireless access point provides a bridge between wired Ethernet LANs and 802.11b/g/n- 
and 802.11a/n-compatible wireless LAN networks. It provides connectivity between wired 
Ethernet networks and radio-equipped wireless notebook systems, desktop systems, print 
servers, and other devices.

In addition, the wireless access point supports the following wireless features:

Aggregation support

Reduced InterFrame spacing support

3 x 3 multiple input, multiple output (MIMO) support

Distributed coordinated function (CSMA/CA, back-off procedure, ACK procedure, 
retransmission of unacknowledged frames)

RTS/CTS handshake

Beacon generation

Packet fragmentation and reassembly

Auto or long preamble

Roaming among wireless access points on the same subnet

Autosensing Ethernet Connections with Auto Uplink

The wireless access point can connect to a standard Ethernet network. The LAN interface is 
autosensing and capable of full-duplex or half-duplex operation. 

The wireless access point incorporates Auto Uplink technology. The Ethernet port 
automatically senses whether the Ethernet cable plugged into the port should have a 
“normal” connection such as to a computer or an “uplink” connection such as to a switch or 
hub. That port then configures itself correctly. This feature also eliminates any concerns 
about crossover cables, as Auto Uplink accommodates either type of cable to make the right 
connection.

Hardware Description

This section describes the top and rear hardware functions of the wireless access point.

Top Panel

The LEDs of the wireless access point are described in the following figure and table: