Netgear WNDAP620 Manual Do Utilizador
Supplemental Information
142
ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP620
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
Note:
Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
the wireless access point to reboot.
Table 40. Default configuration settings
Feature
Description
Login for management and configuration
LAN IPv4 management address
192.168.0.100
Subnet mask for IPv4 management address
255.255.255.0
LAN IPv6 management address
2001::21c:c0ff:fe69
Prefix length for IPv6 management address
64
Required static IPv4 address for management
computer
computer
192.168.0.210 and 255.255.255.0
User name (case-sensitive) for login
admin
Login password (case-sensitive) for login
password
LAN and management features
DHCPv4 client
Disabled
DHCPv6 client
Disabled
Untagged VLAN
Enabled, VLAN ID 1
Management VLAN
VLAN ID 1
SNMP
Disabled
Syslog
Disabled
Spanning Tree Protocol (STP)
Disabled
Link Layer Discovery Protocol (LLDP)
Enabled
Secure Shell (SSH)
Enabled