Netgear WNDAP620 Manual Do Utilizador

Configure the Optional DHCPv4 Server

The wireless access point provides a built-in DHCPv4 server for wireless clients only, which 
can be especially useful in small networks. When the DHCP server is enabled, the wireless 
access point provides preconfigured TCP/IP configurations to all connected wireless stations.

For information about how to configure the DHCPv6 server, see 



Select Configuration > IP > DHCP Server Settings. The DHCP Server Settings screen 
displays. The following figure displays the DHCPv4 server settings only. For information 
about the DHCPv6 server settings, see 

page 101.

Configure the settings as explained in the following table:

Select the DHCPv4 Server check box to enable the DHCP server. Use the default settings or specify the 
pool of IPv4 addresses to be assigned by setting the starting IPv4 address and ending IPv4 address. These 
addresses should be part of the same IPv4 address subnet as the wireless access point’s LAN IPv4 
address.

DHCP Server VLAN ID

Enter the VLAN ID for the DHCP server. The VLAN ID range is from 1 to 4094. 
The default VLAN is 1.

Starting IPv4 Address

Enter the first address in the range of IPv4 addresses to be assigned to DHCP 
clients. The default address is 192.168.1.02.