Netgear WG602NA Manual Do Utilizador

5-4

Advanced Configuration

1.

Configure the Operating Mode of the WG602 v3 Access Points.

–

AP1 on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC Address of 
AP2.

–

Because it is in the central location, configure AP2 on LAN Segment 2 in Wireless 
Multi-Point Bridging mode. Add the MAC addresses of the adjacent Point-to-Point APs 
which are configured to communicating with it.

–

Configure the AP3 on LAN 3 in Point-to-Point Bridge mode with the Remote MAC 
Address of AP2.

2.

Verify the following parameters for all access points:

•

Verify that the LAN network configuration the WG602 v3 Access Points are configured to 
operate in the same LAN network address range as the LAN devices

•

Only one AP is configured in Wireless Multi-Point Bridging mode, and all the others are 
in Point-to-Point Bridge mode.

•

All APs must be on the same LAN. That is, all the APs LAN IP address must be in the 
same network.

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

Wireless PC Card
in a Notebook Computer