Netgear R7500 Manual Do Utilizador

By default, the router is set with standard LED settings. If you turned off the LEDs except the 
Power LED, you must return the LEDs to their standard settings for troubleshooting. For 
information about controlling the LED settings, see 

11.

After you turn on power to the router, the following sequence of events occurs:

When power is first applied, verify that the Power LED 

 is lit.

After about 2 minutes, verify the following:

The Power LED is solid white.

The Internet LED is lit.

The WiFi LED is lit unless you turned off the wireless radio.

You can use the LEDs on the front panel of the router for troubleshooting.

This could be due to the following situations:

Make sure that the power adapter is securely connected to your router and securely 
connected to a working power outlet. 

Check that you are using the power adapter that NETGEAR supplied for this product.

If the Power LED blinks slowly and continuously, the router firmware is corrupted. This 
can happen if a firmware upgrade is interrupted, or if the router detects a problem with the 
firmware. If the error persists, it is likely that a hardware problem exists. For recovery 
instructions, or help with a hardware problem, contact technical support at 

When the router is turned on, the Power LED turns amber for up to 2 minutes and then turns 
white. If the LED does not turn white, this indicates a problem with the router.

If the Power LED is still amber 3 minutes after you turn on power to the router, do the 
following:

Turn off the power and then turn it back on to see if the router recovers.

Press and hold the Reset button to return the router to its factory settings. 

See 

168.

If the error persists, a hardware problem might be the cause. Contact technical support at