Netgear XS712T Manual Do Utilizador
17
XS712T Smart Switch
Step 1: Prepare the Site
Before you install the switch, ensure that the operating environment meets the site
requirements in the following table.
requirements in the following table.
Table 3. Site requirements
Characteristics Requirements
Mounting
•
Desktop installations. Provide a flat table or shelf surface.
•
Rack-mount installations. Use a 19 inch (48.3 centimeter) EIA standard equipment rack
that is grounded and physically secure. The rack-mount kit supplied with the switch is
also required.
that is grounded and physically secure. The rack-mount kit supplied with the switch is
also required.
Access
Locate the switch in a position that allows you to access the front panel RJ-45 ports, view the
front panel LEDs, and access the power connector.
front panel LEDs, and access the power connector.
Power source
Provide a power connection cord. Power specifications for the switch are shown in
. Ensure the AC outlet is not controlled by a wall switch, which can
accidentally turn off power to the outlet and the switch.
Environmental
•
Temperature. Install the switch in a dry area, with ambient temperature between 0ºC and
50ºC (32ºF and 122ºF). Keep the switch away from heat sources such as direct sunlight,
warm air exhausts, hot-air vents, and heaters.
50ºC (32ºF and 122ºF). Keep the switch away from heat sources such as direct sunlight,
warm air exhausts, hot-air vents, and heaters.
•
Operating humidity. The installation location should have a maximum relative humidity of
90%, noncondensing.
90%, noncondensing.
•
Ventilation. Do not restrict airflow by covering or obstructing air inlets on the sides of the
switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be sure
that there is adequate airflow in the room or wiring closet where the switch is installed.
switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be sure
that there is adequate airflow in the room or wiring closet where the switch is installed.
•
Operating conditions. Keep the switch at least 6 feet. (1.83 meters) away from nearest
source of electromagnetic noise, such as a photocopy machine.
source of electromagnetic noise, such as a photocopy machine.
Step 2: Install the Switch
The smart switch can be used on a flat surface or mounted in a standard network equipment
rack.
rack.
Install the Switch on a Flat Surface
This procedure explains how to install the switch on a flat surface.
To install the switch on a flat surface:
Stick one of the provided rubber footpads on each of the four concave spaces on the bottom
of the switch.
of the switch.
The switch ships with four self-adhesive rubber footpads. The rubber footpads cushion the
switch against shock and vibrations.
switch against shock and vibrations.