Netgear DGND3300 Manual Do Utilizador

Safeguarding Your Network

2-15

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless 
network. You must record, and then manually enter your security settings (see 

).

To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:

1. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the 

Wireless Settings screen (see 

). 

and click Apply. 

2. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply. Record this 

information to add additional clients.

3. For the non-WPS devices that you want to connect, open the networking utility and follow the 

utility’s instructions to enter the SSID, WPA/PSK + WPA2/PSK security method, and 
passphrase.

4. For the WPS devices that you want to connect, follow the procedure 

5. To view a list of all devices connected to your modem router (including wireless and Ethernet-

connected), see 

Note: To make sure that your new wireless settings remain in effect, verify that the 

Keep Existing Wireless Settings checkbox is selected in the WPS Settings 
screen.