Netgear VPN Firewall 200 FVX538 Manual Do Utilizador
LAN Configuration
3-1
v1.0, August 2006
Chapter 3
LAN Configuration
This chapter describes how to configure the advanced LAN features of your ProSafe VPN Firewall
200. These features can be found by selecting Network Configuration from the primary menu and
LAN Setup from the submenu of the browser interface.
200. These features can be found by selecting Network Configuration from the primary menu and
LAN Setup from the submenu of the browser interface.
Using the Firewall as a DHCP server
By default, the firewall will function as a DHCP (Dynamic Host Configuration Protocol) server,
allowing it to assign IP, DNS server, WINS Server, and default gateway addresses to all computers
connected to the firewall LAN. The assigned default gateway address is the LAN address of the
firewall. IP addresses will be assigned to the attached PCs from a pool of addresses specified in
this menu. Each pool address is tested before it is assigned to avoid duplicate addresses on the
LAN.
allowing it to assign IP, DNS server, WINS Server, and default gateway addresses to all computers
connected to the firewall LAN. The assigned default gateway address is the LAN address of the
firewall. IP addresses will be assigned to the attached PCs from a pool of addresses specified in
this menu. Each pool address is tested before it is assigned to avoid duplicate addresses on the
LAN.
For most applications, the default DHCP and TCP/IP settings of the firewall are satisfactory. See
the link to “Preparing a Computer for Network Access” in
the link to “Preparing a Computer for Network Access” in
an explanation of DHCP and information about how to assign IP addresses for your network.
If another device on your network will be the DHCP server, or if you will manually configure the
network settings of all of your computers, clear the Enable DHCP server radio box by selecting
the Disable DHCP Server radio box. Otherwise, leave it checked.
network settings of all of your computers, clear the Enable DHCP server radio box by selecting
the Disable DHCP Server radio box. Otherwise, leave it checked.
Specify the pool of IP addresses to be assigned by setting the Starting IP Address and Ending IP
Address. These addresses should be part of the same IP address subnet as the firewall’s LAN IP
address. Using the default addressing scheme, you should define a range between 192.168.1.2 and
192.168.1.100, although you may wish to save part of the range for devices with fixed addresses.
Address. These addresses should be part of the same IP address subnet as the firewall’s LAN IP
address. Using the default addressing scheme, you should define a range between 192.168.1.2 and
192.168.1.100, although you may wish to save part of the range for devices with fixed addresses.
The firewall will deliver the following parameters to any LAN device that requests DHCP:
•
An IP Address from the range you have defined.
•
Subnet Mask.
•
Gateway IP Address (the firewall’s LAN IP address).
•
Primary DNS Server (the firewall’s LAN IP address).
•
WINS Server (if you entered a WINS server address in the DHCP Setup menu).
•
Lease Time (date obtained and duration of lease).