Olicom None Manual Do Utilizador

Connecting the Broadband Wireless Router (AP) 

Connect the Ethernet cable with your xDSL/ATU-R to the 10Base-T Ethernet WAN 

port on your Broadband Wireless Router (AP). 

Note:

 

1.  The attached xDSL/ATU-R must provide a standard 10Base-T Ethernet connection. 

Please use the Ethernet cable provided by your ISP or any other standard 10Base-T 

Ethernet cable. 

2.  The Ethernet cable supplied by your ISP for connecting to your xDSL/ATU-R may be 

an Ethernet crossover cable or a straight-through cable. It is important to use the cable 

provided by your ISP to connect the modem to your Broadband Wireless Router (AP). 

 

Attach one end of the Ethernet cable with RJ-45 connector to the AV port of your 

Broadband Wireless Router (AP).   

The Broadband Wireless Router (AP) incorporates a four-port switch for connection 

to your local Ethernet network. The Ethernet ports are capable of operation at either 

10Mbps (10Base-T) or 100Mbps (100Base-Tx), depending on the Ethernet interface 

of the attached PC, hub or switch. For any connection which will operate at 100 Mbps, 

you must use a category 5 rated cable, such as the Ethernet cable included with the 

Broadband Wireless Router (AP). 

 

You need to check the setting of wireless client stations to match the default settings 

of the Broadband Wireless Router (AP): 

1.  The default SSID: IEEE 802.11 LAN. 
2.  WEP encryption is disabled. Authentication Type is Open Key (or Open 

System according to your Wireless LAN Card). 

3. Use 

Infrastructure connection mode. 

 

Connect the supplied power adapter to the 12VDC port of your Broadband Wireless 

Router (AP), and the other end to a power outlet. 

3