3com MSR 20 Manual Do Utilizador
SIC-1TPRI/SIC-1T1-F
33
Figure 24 Extending an E1 120-ohm balanced twisted pair cable
Step 4: Check the status of LINK LED on the SIC-1EPRI/SIC-1E1-F panel: ON means
the link is connected and OFF means the link is not connected. In the latter case,
check the line.
the link is connected and OFF means the link is not connected. In the latter case,
check the line.
SIC-1TPRI/SIC-1T1-F
Introduction
1-port channelized T1/CT1/PRI compatible interface card (SIC-1TPRI) supports:
■
Transmission/Receiving and handling of T1 data streams;
■
CT1 (channel T1) access;
■
ISDN PRI function;
■
Remote loopback and local loopback, facilitating the effective and flexible
debugging.
debugging.
It is possible to use the card for multiple purposes through different
configurations.
configurations.
Following are the differences between SIC-1TPRI and 1-port Fractional T1 interface
card (SIC-1T1-F):
card (SIC-1T1-F):
■
FT1 mode of SIC-1T1-F can support only one channel bundle (the rate is n
× 56
kbps, n=1-24), while the 24 channels can be grouped into multiple arbitrary
bundles by SIC-1TPRI.
bundles by SIC-1TPRI.
■
SIC-1T1-F does not support PRI mode.
Interface Attributes
The interface attributes of SIC-1TPRI/SIC-1T1-F are given in the following table:
Router
Network
devices such
as DDN
devices such
as DDN
DB-15
Network interface connector
RJ-45
RJ-45
120-ohm balanced twisted pair
120-ohm E1 trunk cable
Table 8 Interface attributes of SIC-1TPRI/SIC-1T1-F
Attribute Description
Connector type
RJ-45
Number of connectors
1