3com 3CRTRV10075 Manual Do Utilizador
6
■
Wireless — select the wireless network with the 3Com SSID (3Com is
the default SSID).
the default SSID).
4 Start your Web browser.
5 In the Location or Address bar, enter the following:
config.ap
This will work only while in Setup/Configuration mode. In AP mode, you
cannot connect. In Router mode, you must connect using the Wireless
LAN IP address.
cannot connect. In Router mode, you must connect using the Wireless
LAN IP address.
6 If the password has been set (by default, it is blank), you will be prompted
for the username and password.
a Enter the username as admin.
b Enter the current password.
7 You will then see the Main Configuration screen. This screen provides
access to the 4 main setup screens:
■
System — settings which are independent of each mode.
■
AP Mode — settings for AP (Access Point) mode.
■
Router Mode - settings for Router mode.
■
Client Mode - settings for Client mode.
8 Configure the System screen and the modes you will use.
Use the on-line help as needed.
Using Each Mode
To change modes, use the mode selector switch on the side of the Travel
Router.
Router.
■
After moving the switch, you need to wait a few seconds for the
Travel Router to become available.
Travel Router to become available.
■
Changing modes will break all existing Wireless connections. You
need to re-connect using the SSID for the current mode. The default
SSIDs are:
need to re-connect using the SSID for the current mode. The default
SSIDs are:
■
Setup/Configuration Mode: 3Com
■
AP Mode:
3Com
■
Router Mode:
3Com