EnGenius Technologies ESR-9710 Manual Do Utilizador
ESR-9710 Wireless N Gigabit Router
Version 1.0
46
L2TP Server IP Address: If the L2TP Server’s IP address is different from the
default gateway, then you may specify it here.
User Name: Specify the user name which is provided by your ISP.
Password: Specify the password which is provided by your ISP, and then verify it
Password: Specify the password which is provided by your ISP, and then verify it
once again in the next field.
Reconnect Mode: Select a reconnection time: Always on (A connection to the
Internet is always maintained), On demand (A connection to the Internet is made as
needed), Manual: You have to open up the Web-based management interface and
click the Connect button manually any time that you wish to connect to the Internet.
needed), Manual: You have to open up the Web-based management interface and
click the Connect button manually any time that you wish to connect to the Internet.
Maximum Idle Time:
Primary / Secondary DNS Address: Specify the primary and secondary IP address,
Primary / Secondary DNS Address: Specify the primary and secondary IP address,
which is assigned by your ISP.
MTU: The Maximum Transmission Unit (MTU) is a parameter that determines the
largest packet size (in bytes) that the router will send to the WAN. If LAN devices
send larger packets, the router will break them into smaller packets. Ideally, you
should set this to match the MTU of the connection to your ISP. Typical values are
1500 bytes for an Ethernet connection and 1492 bytes for a PPPoE connection. If the
router's MTU is set too high, packets will be fragmented downstream. If the router's
MTU is set too low, the router will fragment packets unnecessarily and in extreme
cases may be unable to establish some connections. In either case, network
performance can suffer.
send larger packets, the router will break them into smaller packets. Ideally, you
should set this to match the MTU of the connection to your ISP. Typical values are
1500 bytes for an Ethernet connection and 1492 bytes for a PPPoE connection. If the
router's MTU is set too high, packets will be fragmented downstream. If the router's
MTU is set too low, the router will fragment packets unnecessarily and in extreme
cases may be unable to establish some connections. In either case, network
performance can suffer.
MAC Address: If you need to change the MAC address of the rounter's WAN-side
Ethernet interface, either type in an alternate MAC address (for example, the MAC
address of the router initially connected to the ISP) or click on Clone Your PCs MAC
Address.
address of the router initially connected to the ISP) or click on Clone Your PCs MAC
Address.
Click on the Save Settings button to store these settings.
6.2.5 BigPond
The WAN interface can be configured as BigPong. This type of service is used
through Telstra BigPond Cable Broadband in Australia
Select
the BigPond from the My Internet Connection drop-down list.