Enterasys Networks 1G58x-09 Manual Do Utilizador

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide

This chapter describes the Port Configuration set of commands and how to use them.

The Matrix E1 has fixed front panel ports at the bottom of the chassis and either one or three 
optional Ethernet expansion module slot(s) at the top of the chassis.

Matrix E1 fixed front panels provide the following port configurations:

The 1H582-25 fixed front panel provides 24 RJ45 10/100 Mbps ports.

The 1H582-51

 

fixed front panel provides 48 RJ45 10/100 Mbps ports. 

The 1G582-09 fixed front panel provides 6 RJ45 10/100/1000 Mbps ports. 

The 1G587-09 fixed front panel provides 6 Small Form Factor Pluggable (SFP) 1-Gigabit fiber 
optic ports.

Depending on the Ethernet expansion module(s) installed, each slot provides up to 16 ports via Fast 
Ethernet RJ45 connectors, or Gigabit Ethernet via fiber optic connections using GBICs. 

The expansion module and fixed front panel port numbering scheme used when configuring Matrix 
E1 ports is shown in 

. Ports 1 through 24, or 1 through 48, are RJ45 10/100 Ethernet 

connections, and are designated as 0 for being fixed ports on the front panel. In this numbering 
scheme, front panel port 8 is expressed as 0.8 in the CLI syntax. 

NOTE: Illustrations and most of the examples in this guide are based on the Matrix E1 
1H582-51. Configuration and CLI output for the Matrix E1 1H582-25 and 1G58x-09 may 
be different. Unless noted, procedures and performance features are similar for both 
models.