Enterasys Networks 1G58x-09 Manual Do Utilizador
Process Overview: Routing Protocol Configuration
Configuring OSPF
13-35
no ip ospf transmit-delay
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to set the time required to transmit a link state update packet on VLAN 1
at 20 seconds:
at 20 seconds:
13.1.2.9 ip ospf hello-interval
Use this command to set the number of seconds a router must wait before sending a hello packet to
neighbor routers on an interface.
neighbor routers on an interface.
ip ospf hello-interval seconds
Syntax Description
Command Syntax of the “no” Form
The “no” form of this command sets the hello interval value to the default (10
seconds for broadcast and point-to-point networks, 30 seconds for non-broadcast
and point-to-multipoint networks):
seconds for broadcast and point-to-point networks, 30 seconds for non-broadcast
and point-to-multipoint networks):
no ip ospf hello-interval
Command Type
Router command.
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip ospf transmit-delay 20
seconds
Specifies the hello interval in seconds. Hello interval must
be the same on neighboring routers (on a specific subnet),
but can vary between subnets. This parameter is an unsigned
integer with valid values between 1 and 65535.
be the same on neighboring routers (on a specific subnet),
but can vary between subnets. This parameter is an unsigned
integer with valid values between 1 and 65535.