TANDBERG D13202 Manual Do Utilizador
TANDBERG GW
Dataport Command Interface User Guide
D13202 Rev 01
8
case where the user is trying to transfer a call from an inactive GW port (the user input is
shown in bold).
shown in bold).
calltransfer 1 999999
*R Invalid gateway id
ERROR
Parameter Setting Commands are commands that set a system parameter to a specific value.
E.g.: The command ippassword sets the valid password needed to establish an IP connection
with the GW to a specific value.
E.g.: The command ippassword sets the valid password needed to establish an IP connection
with the GW to a specific value.
If the command is syntactically correct the GW returns OK, otherwise the GW returns
ERROR. If *P parameter feedback is activated (ref. command feedback), and the parameter
is successfully changed, the GW will return the command with the new value. An example of
*P parameter feedback is shown below (the user input is shown in bold).
ERROR. If *P parameter feedback is activated (ref. command feedback), and the parameter
is successfully changed, the GW will return the command with the new value. An example of
*P parameter feedback is shown below (the user input is shown in bold).
pardial on
OK
*P pardial on
When issuing a Parameter Setting Command with no parameter, the GW will return the
command with the current setting. E.g.:
command with the current setting. E.g.:
pardial
*P pardial on
OK
Status Commands are commands that list different sets of system parameters. If *S status
feedback is activated (ref. command feedback), status commands are automatically called
when corresponding parameters are being changed.
feedback is activated (ref. command feedback), status commands are automatically called
when corresponding parameters are being changed.
4.2. The
commands
The commands are divided into five groups: System Configuration Commands, General GW
Commands, System Status Commands, Debug Commands and Special Commands.
Commands, System Status Commands, Debug Commands and Special Commands.