Extron electronic dip hdmi Manual Do Utilizador

When the DXP receives an SIS command and determines that it is valid, it performs the 
command and sends a response to the host device. If the switcher is unable to perform 
the command because the command is invalid or contains invalid parameters, the switcher 
returns an error response to the host. The error response codes are:

E01

 — Invalid input channel number (out of range) 

E10

 — Invalid command 

E11

 — Invalid preset number 

E12

 — Invalid output number or port number 

E13

 — Invalid parameter (out of range) 

E14

 — Command not available for matrix configuration 

E17

 — System timed out (caused by direct write of global presets) 

E21

 — Invalid room number 

E22

 — Busy 

E24

 — Privilege violation (Ethernet and Extron software only) 

E25

 — Device not present 

E26

 — Maximum number of connections exceeded 

E27

 — Invalid event number 

E28

 — Bad filename or file not found 

E30

 — Hardware failure (followed by a colon [:] and a descriptor number) 

E31

 — Attempt to break port pass-through when it has not been set

NOTE:  User privileges extend to all view and read commands except reading the 

administrator password. Users can also perform the following functions:

 

•

  Creating ties 

•

  Recalling presets 

•

  Muting outputs

 begin on page 55. Upper- and lowercase letters 

are acceptable in the command field except where indicated. The table below shows the 
hexadecimal equivalent of each ASCII character used in the command/response table.

•

Space

Use of the following characters is not recommended as part of preset names, the switcher 
name, passwords, or locally created file names:
+ ~ , @ = `

 

[] {} < > ‘’ “” ; (semicolon) : (colon)

 

|

 

\ ? and {space}.