Huawei E960 Manual Do Utilizador

 

25 

or 

assigning I  addresses in a LAN. DHCP automatically assigns IP addresses to the network 
devices.

ou are using the DHCP server, you need to do the following configurations on 

refer to "Configuring the PC Network." 

In the dynamic host configuration protocol (DHCP) settings page, you can set the mode f

P

 If y

the PC connecting with the gateway. For details, 

Click 

  to open the DHCP setting page.   

y  IP Address: The default IP address of the gateway is 192.168.1.1. 

Subnet Mask: The combination of the subnet mask and IP address enables the flexible 
subnetting. By default, the subne

y 

t mask is 255.255.255.0. 

t 

y 

 

s. 

y 

nnected to the network. When the leased time expires, the DHCP server checks 

 device is connected to the network. If the device is disconnected from the 

e server assigns the IP address to another device. Thus, the IP address is not 

waste

  No

y 

art IP Address must be smaller than or equal to the End IP Address. 

y  If the DHCP Server is Enabled, the configurations of Start IP Address, End 

IP address, and DHCP Lease Time are valid; otherwise, you cannot configure 
them.

y  DHCP Server: It is used to assign IP addresses dynamically. If the DHCP server is 

Enabled, it can automatically assign IP addresses for PCs. It is recommended to selec
Disabled for the DHCP server. 
Start IP Address& End IP Address: It is used to define the IP address range that the 
host can use during the IP address assignment. For example, in the network segment
192.168.1.0/24, the default IP address of the E960 is 192.168.1.1. The host IP address 
can range from 192.168.1.2 to 192.168.1.254. The minimum range is a single IP addres
DHCP Lease Time: The DHCP server automatically assigns an IP address to each 
device co
whether the
network, th

d. 

The St