Avaya X330W2-DS1 Manual Do Utilizador
WAN CLI Commands
Avaya X330W-2DS1 User’s Guide
129
Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command only when framing esf is defined.
1. This command can only be performed if the controller is set to T1.
2. Use this command only when framing esf is defined.
The syntax for this command is:
[no] fdl
[no] fdl
<fdl-mode>
Example:
X330WAN-2DS1-1(configure)# fdl ansi
fragment size
Use the fragment size command to set the maximum number of fragmented IP
packets, destined to the router, to reassemble at any given time. Use the no form of
this command to set the fragment size to the default value (100).
packets, destined to the router, to reassemble at any given time. Use the no form of
this command to set the fragment size to the default value (100).
Note:
No fragmentation will be done of packets in transit through the router.
The syntax for this command is:
[no] fragment size
[no] fragment size
<database-limit>
Example:
X330WAN-2DS1-1(configure)# fragment size 150
fragment timeout
Use the fragment timeout command to set the maximum number of seconds to
reassemble a fragmented IP packet destined to the router. Use the no form of this
command to set the fragment timeout to the default value (10).
reassemble a fragmented IP packet destined to the router. Use the no form of this
command to set the fragment timeout to the default value (10).
Note:
No fragmentation will be done of packets in transit through the router.
fdl-mode
ansi | att | both
database-limit
The maximum number of packets undergoing re-assembly at
any given time. The default is 100.
any given time. The default is 100.